i got which i think most aren't right but here they are:
not sure if the answers right thou as there's a pattern but they are the only asnwers that made sense to me everyother anwser seemed wrong
so then i guess it's just me since everyone thought it was an EASY exam and what did you guys write in the first part factor of safety in manufacture of marterials and all that i just want to see wether i was on track as i might have stuffed up as everyone things it was easy except me
um guys i don't know if the exam in every state is different which i thing it is but i found the nsw test hard but there were some areas which i could work out that were not easy and i would certainly say that it was not an easy exam and also if yoiu check the nsw hsc exam for 2005 is totally...
just want to tell everyone out there good luck and not to stress about the exam and remember engineering studies is about taking in what you know and using it to find out what you don't know and finally good luck and hope everyone goes good
hi guys i just finised and just wondering how everyone went on the exam i think it was alright and also one thing that has confused me is did you guys notice for image inststuions and wilfred owens poetry were all essay or is it just me? someone please tell me to so i can clear my thoughts about...
first you need to find the power required for the truck without the panels
you need to use the power formula p=fs/t
10 tonnes =100kn
p for trucks = 19.59*100/20=97.95kW is power required for the truck
power left for panels =total power -...
i have been so far going over past hsc papers and i think i have the answer to 2005 hsc paper question 14 part b (i) where you have to find the maximum number of panel the truck can hold.I got an anwers 4.01 panel which comes to 4 panels and i tried the anwer in two different methods...
thank you very much for you help i sort of get the picture however i was just wondering where you got the 2 from that you times by 100 which equals
which equals to 115.47 in compression which you had which is correct i'm just wondering how you got the 2 and where from i would...
i have this question about truss analysis this is the url for the website it's question 7 part (b) i get an answer of 144.34 n for member bc the answer the website has is 115.5n and the member is in compression and also what is the best way to learn practice truss analysis as it's the only...