• Best of luck to the class of 2024 for their HSC exams. You got this!
    Let us know your thoughts on the HSC exams here
  • YOU can help the next generation of students in the community!
    Share your trial papers and notes on our Notes & Resources page
MedVision ad

Q14 Solutions (1 Viewer)

Fred2013

Member
Joined
Aug 6, 2013
Messages
34
Gender
Male
HSC
2013
GUYS
i manipulated the equation into
te^t - 1 = 0, and i let f(t) equals that
Then applied newton's method, i got ~ 0.570...
IS THAT WRONG?!?
I wrote 0.57... = ~ 0.56
!!!!
 

lijincheng

New Member
Joined
Jun 15, 2012
Messages
5
Gender
Female
HSC
2013
no it's not fine because i got 0.57 too only because i differentiated e^x wrong, i differentiated it into xe^x for some odd reason. and that's what i got.
 

Fred2013

Member
Joined
Aug 6, 2013
Messages
34
Gender
Male
HSC
2013
no it's not fine because i got 0.57 too only because i differentiated e^x wrong, i differentiated it into xe^x for some odd reason. and that's what i got.
well i didnt differentiate wrong.. (pretty sure i didnt)
 

doublem

New Member
Joined
Apr 11, 2012
Messages
3
Gender
Male
HSC
2012
You're a good man, Sy.
Thank you so much for the solutions!
 

aimpacc

Member
Joined
Jan 28, 2012
Messages
77
Location
trolololololol
Gender
Undisclosed
HSC
2013
is it ok to round off the last question to 0.1??? thats wat i did....they might want 0.097 idk will i lose marks?
 

uart

Member
Joined
Dec 10, 2008
Messages
67
Gender
Male
HSC
N/A
is it ok to round off the last question to 0.1??? thats wat i did....they might want 0.097 idk will i lose marks?
Ok I finally got a copy of the exam so I can now comment. :)

In my opinion the numerical approximation of 0.1 (one significant digit) should be fine. The data you were given, t1~=0.56, was itself only accurate to 2 significant digits, and in general the series of calculations required would yield a result with less accuracy than that of the input data.

There are likely two different (correct) expressions for "r" that students may have gotten in this question. The result I obtained was:



My method and results were pretty much the same as that of Sy123 in the OP. Numerically this expression yields an approximation of 0.094 for r. If however you work out a more precise value for t1, then you find that r is actually 0.09726 (to 4 s.d). So to be honest, your answer of 0.1 is probably better than leaving it as 0.094. Personally I just wrote down 0.094, but noted that this is an approximate value and not necessarily accurate to the number of significant digits written. I think this is fair enough too.

I noticed that Terry Lee started with the same two simultaneous equations but derived an alternative expression of:



Since t1 is the solution to exp(t1) = 1/t1, then clearly these two solutions are identical if an exact value of t1 is used. Quite by coincidence however, it turns out that this latter expression is less sensitive to errors in the input value t1, and thus yields an approximate value of r equal 0.097, which is correct to 2 s.d.

Hope this helps.
 
Last edited:

Users Who Are Viewing This Thread (Users: 0, Guests: 1)

Top